***THIS IS A PRE-ORDER; LEAD TIMES MAY APPLY.***
***THIS PART REQUIRES GUNSMITHING AND IS INSTALLED BY THE CUSTOMER/GUNSMITH.***

Designed for use with the Beretta factory 4.9″ non-threaded barrel, the compensator is installed by threading your factory non-threaded barrel with .575-40 compensator thread. The two port Jarvis Compensator effectively reduces muzzle rise enabling the shooter to produce smaller group sizes when firing rapidly and get back on target quicker after firing. With a sleek, full profile design, the Jarvis Compensator attaches with ease by simply threading on to your barrel.  Works with the Beretta 92, 96, M9, Taurus PT92/PT99, and PT101 models.

NOTE: THIS COMPENSATOR IS THREADED WITH A .575-40 THREAD.  FOR MORE INFORMATION REGARDING INSTALLATION, PLEASE READ THE PRODUCT INFORMATION AT THE BOTTOM OF THE PAGE.

Installation Options - Installed By Customer

Color - Black

Caliber - 9MM (Models M9, 92, PT92, PT99)

Model - Full Size

SPECS:

-Length: 1.375″

-Material: Carbon Steel

-Finish: Black

-Weight: 3.5 oz

INCLUDES:

-Light Weight Recoil Spring

-Set Screw

-Hex Key Wrench

-Threadlocker

INSTALLATION & FITTING:

This compensator attaches to your 4.9″ Beretta factory non-threaded barrel. The compensator is designed with the purpose of preventing the customer from being forced to purchase a threaded barrel in order to attach a comp.  To install the compensator, we thread the portion of your factory 4.9″ barrel that extends past the slide.  Once your factory barrel is threaded, we then remove material from the rear surface of the compensator until it references correctly with the slide and has no more than a .004″ gap between the compensator and slide.  This is done to create an aesthetically pleasing appearance and also ensures that the slide is not making contact with the rear surface of the comp when the pistol goes into battery. Installation and fitting requires your slide and factory barrel to be sent in to your gunsmith!

BERETTA M9A3:

This compensator will NOT attach to the Beretta factory 1/2-28 threaded barrel. 

A1 MODELS:

This compensator is designed around the 92 FS/Vertec slides.  It is not an exact profile match to any of the model A1 Beretta’s (92A1, M9A1, 96A1) or Brigadier slides.  The compensator will, however, function on all Beretta 92, M9, and 96 slides.

ADDITIONAL INFO:

This compensator must be used with the reduced power recoil spring provided with the compensator.